If you’re like me I was always looking to find the best solution for a charging station for all the gadgets and tools around the house.
I would like to share with you & the world my version of a simple charging station that is low cost and simple to make. No drilling required, easy to put on any surface & most important “instant” to make.
I present to you SAMLA Instant charging station.
Hope you’ll like it
Step 1: Requirements
Things you’ll need to make your instant charging station:- SAMLA BOX
– SAMLA INSERT
– Power strip
– Velcro squares
Step 2: Inserting Power Strip
Insert power strip through SAMLA INSERT handle.
Step 3: Use Velcro
After inserting the power strip cable through the handle stick 2 Velcro squares on the back of your Power strip.(Hint: use both the male & female velcro so you’ll have double sticky back that will be helpful for the next step)
Step 4: Position The Power Strip
Position and stick your power strip inside the SAMLA box.
Step 5: The End
Insert the SAMLA INSERT inside the box & pull your cable gently.That’s it. Very simple & not a single mess.