I installed the wall mounted rails for the ALGOT shelf system and something has gone wrong. We were careful to measure properly but the shelves will not connect properly to the brackets. Instead, three of the four edges click into the bracket but then there is a gaping hole not allowing for the fourth edge to connect. (See pictures.)
PLEASE HELP! Has this happened to anyone else? I have so many holes in my wall that I’m on the verge of a breakdown.
Firstly, you’re not alone. Many have gone bonkers installing the ALGOT system.
And we’ve had a few posts on ALGOT installation problems: See here and here. Though the problems they had were with the ALGOT wire mesh baskets, they may give you a few clues on installing the shelves.
Also do try these steps (from the assembly manual) in adjusting the width of the ALGOT uprights. It looks like you may need to inch the left upright towards to right.